Installation and Maintenance Manual

Wireless Sensors
UNT-SVX07D-EN 81
4. Review the display to ensure that you have selected the
correct configuration.
5. To return the display to op
erating mode, press the
configuration button (see Step 1, p. 79).
Note: T
he sensor will revert to operating mode if no
buttons are pressed for 10 minutes.
Optional Features
Displaying Setpoint or Temperature. You can
configure the sensor to display either the temperature
(default) or setpoint. To select either option:
1. Verify that the sensor is in operating mode and at the
home screen.
2. Press the up and down arrow
s for 3 seconds. The arrow
indicates setpoint display, as shown in the figure.
Setting Configuration Options
Temperature
• Choose Fahrenheit or Celsius
• Choose the degree resolution
(whole degrees, half degrees, or
tenths of degrees).
Setpoint
System
Fan
Note: Not all fan options are available
for all systems.
Occupancy (timed override)
. .
.
.
.
.
dual setpoint
no
setpoint
single
setpoint
no system
options enabled
auto/off/low
med/high
auto/off/
low/high
auto/off
off/high (on)
off/low/high off/low/
med/high
no fan options
enabled
(Default)
UNT-SVX07_-EN.book Page 81 Friday, April 27, 2012 9:40 AM