Installation and Maintenance Manual

Wireless Sensors
80 UNT-SVX07D-EN
The display will change to configuration mode. When the
sensor is in configuration mode, a wrench symbol appears
on the display and the menus are separated by lines, as
illustrated below.
2. Press the center button on the keypad to begin the
configuration process.
3. Configure the sensor options in the order shown in the
table.
• Press or to scroll to the next selection (as
illustrated).
• Press or to move to the next menu (as
illustrated).
Configuration
button
Center button
UNT-SVX07_-EN.book Page 80 Friday, April 27, 2012 9:40 AM