Installation and Maintenance Manual

Wireless Sensors
UNT-SVX07D-EN 79
Configuring the Wireless Display Sensor
(Model WDS only)
Note: Sensors shipped with the fan-coil are pre-
configured for three speeds.
The configuration of the sensor determines which system
features can be accessed and changes can be made by the
tenant (for example, changes to cooling/heating mode,
setpoint, or fan speed. Verify system and associated unit
features before configuring the sensor.
The building owner or operator may choose to limit tenant
access to certain features. This can be done through
configuration. Or, if a sensor is configured to match all
control capabilities of the building automation system, the
locking feature can be used to restrict the tenant from
making changes.
Configuration Procedure
To configure settings on the model WDS sensor, follow
this procedure in the order presented.
1. Press the configuration button for 3 seconds.
LED1
LED2
LED3
LED5
Model WZS sensor
Push firmly,
then release
Test button
Model WDS sensor
Test button
Push firmly,
then release
UNT-SVX07_-EN.book Page 79 Friday, April 27, 2012 9:40 AM