Installation Guide

WATER PUMP BELT ADJUSTMENT & REPLACMENT

The Water pump belt is used to cool the engine. If the tension is too loose or too tight, it will cause

engine overheating. If you hear the belt slipping or squealing, you should check the following. Ad-

just or Replace.

Belt deection test:

7~10mm(0.28-0.35in/100N{10.01kgf(22.1 lbs)}

Adjust deected belt:

• Stop the engine.

• Use the thumb to press on the belt of the pulley wheel.

• If the tightness is not correct, adjust it by relaxing the regulating wheel, until to the acceptable

degree.

• Replace the water pump belt when it’s cracked, mission sections of the belt, or broken.

AIR FILTER MAINTENANCE

Take out the air lter cartridge and clean it based on the maintenance table (on page 43). The steps

are as follows:

• Remove air lter cover, take out air lter element.

• IMPORTANT. Blow air from the inside of the element toward the outside.

• Clean the lter element using air lter cleaner, dry with compressed air. IMPORTANT! Do not

clean with water.

• Replace cracked or damaged air lter elements as soon as possible.

• Reinstall air lter cartridge and air lter cover. Secure clamps.

Open here

18-SG02D1-1A-EN