Full Product Manual
32
032-5095-1A-EN
Emission System and Maintenance
1. The emission system and its running condition is a vital part of the generator and its overall performance. If
this system is maintained and checked on a regular basis, the standby generator will provide decades of
dependable service. It is extremely important to listen and visually inspect the generator from time to time
during regular operation or during routine exercise mode. If smoke or unusual smells or sounds are
experienced, push the emergency stop switch and do not run the devices until full inspection has been
performed by authorized service provider. The following parts are available by the manufacturer through
EquipSource LLC d/b/a Lifan Power USA. Any non-original equipment (O.E) or non-approved part will void
warranty and could alter emission control requirements.
Part Name Part Number Qty. per unit
Air lter 025A0120 1
Mufer 020B0050 1
Igniter 025A0121 1
Spark plug 025A0122 4
Mixer 015A0106 1
Sensors
Speed sensor 015A0418 1
Crankshaft position sensor 020A0123 1
Water temp sensor 015A0405 1
Oil sensor 020A0124 1
Intake pressure sensor 020A0999 1
Camshaft position sensor 020A0126 1
Oxygen sensor 020A0127 1
Electrical control components
ECU 020A0128 1
Actuator 020A0129 1
Engine
PD465QR 020A0009 1
Mechanical components
Catalytic Converter 020A0104 1
Fuel switch valve 020A5250 1
Regulator 020A0006 1