Full Product Manual

Engine Prestart & Preparation

All necessary installation and annual maintenance must be conducted and performed by an authorized licensed

TRANE® Standby specialist to prevent warranty violation. If end-user changes and maintains oil, air and cool-

ant service, they must maintain log, receipts and take pictures of hour meter at the time of service for verica-

tion.

Before starting engine for the rst time, engine oil and radiator coolant must be added. An initial uid

inspection and pre-check is recommended before starting genset for the rst time or after unit has been in

operation for over 50 hours. It can also be used as a quick review of all uids. Check all of the following items

before running system for the rst time.

IMPORTANT NOTE! Unit is not shipped with engine oil or coolant from Factory!!

After installment of generator, ll engine with recommended oil weight based on ambient temperature shown

below and add radiator coolant. Prior to initial startup, replace all service panels and close lid. Start engine and

allow 10 minutes for system to warmup. After this has been performed, remove service panels, lift the lid, and

check for any leaks or drips. If found, tighten lose hoses, clamps or plugs. Recheck all uid levels and top off

as necessary.

1. Engine Oil. The unit is not shipped with oil from factory! Use high-quality synthetic motor oil “Classied

for Service with SAE viscosity ratings. Fill with the recommended amount of oil as specied. Overlling or un-

der lling can cause damage to the engine. Only use the following recommended engine oil.

Temperature

Mobil 1 Synthetic Oil or equivalent recommended

Below 32° F (0° C) SAE 0W-40

32° to 80° F (-1° to 27° C) SAE 10W-40

Above 80° F (27° C) SAE 15W-50

• Place funnel in engine oil inlet.

• First time operation will require 4 liters or (4.25qts) of oil

• Check oil gauge dipstick regularly, oil level should be kept between top and bottom lines, at all

times. It is preferred to be at the top mark but not over.

Fuel Oil Level Mark

Engine Oil

032-5095-1A-EN