Installation Guide

Generator Electrical Access Port
Easy Controller receptacle on
Generator
Controller wiring harness inside ATS
with Easy Connection
Wires / cables hose
• The connection receptacle is located on the back side of control panel inside the standby
generator. Remove rear panel to view the connection, from ATS. The wire will go out through
the wire outlet on the enclosure., passing harness through wire access in standby
• When all priority circuits have been moved to the transfer switch, close the main breaker to
restore utility power and make sure utility voltage at the transfer switch is correct. Refer to
NFPA 70-E for safety equipment required when working inside a live transfer switch.
AC output terminal
ATS connection
27
18-SG02D1-1A-EN