Installation and Maintenance Manual

Controls
RTAE-SVX001B-EN 53
3. Touch Save.The Settings screen appears with only the
Security button visible. The Log in/Logout button is
gone.
To enable security:
1
. From the Settings screen, touch the Security button.
The Security screen appears (Figure 48).
2. Touch the Enable button.The button becomes shaded.
3. Touch Save.The Settings screen appears with a Log
out
button, in addition to the Security button.
Logging In
There are two levels of security:
• Security Level 1 allows users to change a limited group
of
secure settings.The default security PIN is 1111.
• Security Level 2 allows users to change all secure
set
tings.The default security PIN is 7123.
A technician must use theTracerTU service tool to define
a
different PIN, or to recall a PIN that has been forgotten.
When defining a PIN inTracerTU, the technician enters a
4-digit PIN that corresponds with the desired level of
security.
To log in:
1. Touch the Log in button.The Log in screen appears
(Figure 49).
2. Use the keypad to enter your PIN.
a. The PIN is a four-digit number, which was
configured
for your system with theTracerTU
service tool.
b. As you enter the number, the PIN remains hidden
by asterisks.
Note: If you enter an invalid PIN, an error message
appears on the Log in screen.
3. Touch Save.
a. If you viewed the Log in screen from touching Log
in
on the Settings screen, the Settings screen
appears with a Log out button on it.
b. If the Log in screen appeared when you tried to
change a setting, you return to that setting screen.
Note: The PIN is valid until 30 minutes of inactivity
passes, or until you log out.
Logging Out
To log out:
1. Touch the Log out button. A confirmation screen
appears (Figure 51).
2. TouchYes to confirm that you want to log out.The
S
ettings screen appears with a Log in button on it.
Figure 48. Security screen - disable
Figure 49. Security settings screen
Figure 50. Log in screen
Figure 51. Log out confirmation screen