Installation and Maintenance Manual
14 RTAE-SVX001B-EN
Dimensions and Weights
Weights
Unit Dimensions
See unit submittals for specific unit dimensions and water connection locations.
Service Clearances
Table 5. Weights
Unit Size
(tons)
Standard Length Unit
Extended Length Unit
(a)
Shipping Operating Shipping Operating
lbs kg lbs kg lbs kg lbs kg
InvisiSound™ Standard or Superior
(b)
150S 9436 4280 9596 4353 11013 4995 11173 5068
165S 10451 4741 10611 4813 12011 5448 12171 5521
150 11333 5141 11479 5207 13492 6120 13638 6186
165 12377 5614 12533 5685 14532 6592 14688 6662
180 12698 5760 12880 5843 14853 6737 15035 6820
200 13808 6263 14007 6354 15991 7254 16213 7354
225 15244 6915 15466 7015 17427 7905 17649 8005
250 15622 7086 15861 7195 17805 8076 18044 8185
275 16820 7630 17095 7754 18975 8607 19250 8732
300 17965 8149 18265 8285 20121 9127 20421 9263
InvisiSound Ultimate
(c)
150S 10236 4643 10396 4716 11813 5358 11973 5431
165S 11251 5103 11411 5176 12811 5811 12971 5884
150 12133 5504 12279 5570 14292 6483 14438 6549
165 13177 5977 13333 6048 15332 6955 15488 7025
180 13498 6123 13680 6205 15653 7100 15835 7183
200 14608 6626 14807 6716 16791 7616 17013 7717
225 16044 7278 16266 7378 18227 8268 18449 8368
250 16422 7449 16661 7557 18605 8439 18844 8548
275 17620 7992 17895 8117 19775 8970 20050 9095
300 18765 8512 19065 8648 20921 9490 21221 9626
(a) Units are extended length if either of the following are selected:
Transformer (model number digit 28 = 1)
Harmonic Filtration Option (model number digit 29 = 1)
Units without Harmonic Filtration Option or Transformer (digits 28, 29 = 0X) are standard length.
(b) Model number digit 12 = 1 or 2
(c) Model number digit 12 = 3
Figure 5. RTAE service clearances - top view
NOTES:
1. A full 40” clearance
is required in front
of the control panel.
Must be measured
from front of panel,
not end of unit base.
2. Clearance of 85”
on the side of the
unit is required for
coil replacement.
Preferred side for
coil replacement is
shown (left side of
unit, as facing control
panel), however either
side is acceptable.
36” (914.4mm)
40”
(1016
mm)
24”
(600.1mm)
Control
Panel
NO OBSTRUCTIONS ABOVE UNIT
TOP VIEW
See
note 1
85” (2160mm)
See note 2