Catalogue

20 RLC-PRC042D-EN
Controls
Tracer TU Interface
Tracer™ TU (non-Trane personnel, contact your local Trane office for software) adds a level of
sophistication that improves service technician effectiveness and minimizes chiller downtime. The
Tracer AdaptiView™ control’s operator interface is intended to serve only typical daily tasks. The
portable PC-based service-tool software, Tracer TU, supports service and maintenance tasks.
Tracer TU serves as a common interface to all Trane
®
chillers, and will customize itself based on
the properties of the chiller with which it is communicating. Thus, the service technician learns only
one service interface.
The panel bus is easy to troubleshoot using LED sensor verification. Only the defective device is
replaced. Tracer TU can communicate with individual devices or groups of devices.
All chiller status, machine configuration settings, customizable limits, and up to 100 active or
historic diagnostics are displayed through the service-tool software interface.
LEDs and their respective Tracer TU indicators visually confirm the availability of each connected
sensor, relay, and actuator.
Tracer TU is designed to run on a customer’s laptop, connected to the Tracer AdaptiView control
panel with a USB cable. Your laptop must meet the following hardware and software requirements:
• 1 GB RAM (minimum)
• 1024 x 768 screen resolution
• CD-ROM drive
• Ethernet 10/100 LAN card
• An available USB 2.0 port
• Microsoft
®
Windows
®
XP Professional operation system with Service Pack 3 (SP3) or
Windows 7 Enterprise or Professional operating system (32-bit or 64-bit)
• Microsoft .NET Framework 4.0 or later
Note: Tracer TU is designed and validated for this minimum laptop configuration. Any variation
from this configuration may have different results. Therefore, support for Tracer TU is
limited to only those laptops with the configuration previously specified.