Installation and Maintenance Manual
Table Of Contents
- Warnings, Cautions and Notices
- Model Number Description
- General Information
- Pre-Installation
- Unit Dimensions/Weights
- Installation - Mechanical
- Location Requirements
- Rigging
- Evaporator Piping
- Condenser Water Piping (RTWD Units Only)
- Refrigerant Relief Valve Venting
- RTUD Installation
- System Configuration
- Equivalent Line Length
- Liquid Line Sizing
- Discharge (Hot Gas) Line Sizing
- Example
- Refrigerant Charge Determination
- RTUD Chilled Water Flow Control
- Oil Charge Determination
- Outdoor Air Temperature Sensor Installation Requirements
- Fan Control for the Remote Air Cooled Condenser
- RTUD Condenser Elevation Setting
- Shipping Spacers
- Installation - Electrical
- RTWD/RTUD Operating Principles
- Controls Interface
- Pre-Start Checkout
- Unit Start-Up Procedures
- Unit Shutdown
- Service and Maintenance
- Diagnostics
- Wiring Schematics
Unit Dimensions/Weights
RLC-SVX09H-EN 27
Figure 9. Trane air-cooled condenser -
80T, 150T (cond 1 & 2), 160T (cond 1 & 2), 180T (cond 1)
Approx. center of gravity
Disconnect
switch
Service panel
Electrical box
split controls
Return bend cover
Inlet connection
Outlet connection
166.0‚
90.5‚
45.25‚
93.0‚
54.0‚ 54.0‚
54.0‚
166.0‚
22.0‚
90.5‚
86.5‚
58.5‚
184.0‚
64.0‚
8.0‚
10.0‚
0.75 inch anchor holes
Figure 10. Trane air-cooled condenser -
90T, 100T, 110T, 180T (cond 2), 200T (cond 1 & 2), 220T (cond 1 & 2), 250T (cond1&2)
Return bend cover
Electrical box
split controls
Outlet connection
Inlet connection
Service panel
Disconnect switch
220.0‚
90.5‚
45.25‚
120.0‚
Approx. center of gravity
108.0‚
108.0‚
220.0‚
238.0‚
22.0‚
64.0‚
58.5‚
86.5‚
90.5‚
10.0‚
8.0‚
0.75 inch anchor holes