Installation and Maintenance Manual

Controls Interface
RLC-SVX09H-EN 141
Display Settings Screen
Upon selecting a Settings list all setpoints available to
change along with their current value will appear.The
operator selects a setpoint to change by touching either
the verbal description or setpoint value. Doing this causes
the screen to switch to either the Analog Settings
Subscreen or the Enumerated Settings Subscreen.
Analog Setting Subscreens
Analog Settings Subscreen displays the current value of
the chosen setpoint in the upper ½ of the display. It is
displayed in a changeable format consistent with its type.
Binary setpoints are considered to be simple two state
enumerations and will use radio buttons.Analog setpoints
are displayed as spin buttons.The lower half of the screen
is reserved for help screens.
All setpoint subscreens will execute the equivalent of a
Cancel key if any display activities cause the subscreen to
be left before a new setpoint is entered. E.g. if the Alarms
key is pressed before a new setpoint is entered, the new
setpoint will be cancelled.The same applies to any time-
outs.
Pressing the Auto or Stop keys will not cause a cancel
since the setpoint subscreen is not left on this action.
Enumerated Settings Subscreen
The enumerated setpoint subscreen has no cancel or enter
key. Once a radio key is depressed the item is immediately
set to the new enumeration value.
Mode Override Subscreens
The Mode Override subscreen has no cancel or enter key.
Once a radio key is depressed that new value is
immediately assumed.
Table 113. Display settings
Description
Resolution or (Enumerations),
Default Units
Date Format
(“mmm dd, yyyy”, “dd-mmm-yyyy”),
“mmm dd, yyyy
Enum
Date
3
Time Format (12-hour, 24-hour), 12-hour Enum
Time of Day
3
Keypad (Display
Lockout
2
(Enable, Disable), Disable Enum
Display Units (SI, English), SI Enum
Pressure Units (Absolute, Gauge), Gauge Enum
Language
4
(English, Selection 2, Selection 3),
English
1
Enum
Notes:
1. Language choices are dependent on what the Service Tool has setup
in the Main Processor. Get Radio Button names from Main Processor
setups. Language selections will include English and qty 2 alternate
as loaded by TechView.
2. Enables a DynaView Lockout screen. All other screens timeout in 30
minutes to this screen. The DynaView Lockout Screen will have 0-9
keypad to permit the user to re-enter the other DynaView screens
with a fixed password (159).
3. The Date and Time setup screen formats deviate slightly from the
standard screens defined above. See the alternate screen layouts
below.
4. Language shall always be the last setting listed on the Control
Settings menu (which will also always be the last item listed on the
Settings menu list). This will allow a user to easily find language
selection if looking at an unrecognizable language.