Programming Guide

Programming Configuration
42 PKG-SVP01D-EN
Configuration - Model Num Digit 33
Remote Human Interface INSTALLED
Used With: All Units
Possible Values: installed, Not Installed
1. Press the NEXT key until the following screen is displayed.
Unit Model Number
Used With: All units unless RTM has been changed.
Possible Values: Model Number
1. Pressing the NEXT key will scroll forward through the screens.
Software Revision Number Report:
RTM 9.13
1. Pressing the NEXT key will scroll forward through the screens.
Software Revision Number Report:
Multiple Compressor Module (SCM) 1.00
1. Pressing the NEXT key will scroll forward through the screens.
Software Revision Number Report:
Multiple Compressor Module (MCM) 4.09
1. Pressing the NEXT key will scroll forward through the screens.
Software Revision Number:
GBAS 0-5 VDC Module 1.00
Used With: Units with GBAS
1. Pressing the NEXT key will scroll forward through the screens.
Software Revision Number Report:
Ventilation Override (VOM) 1.00
Used With: Units with VOM module installed
1. Pressing the NEXT key will scroll forward through the screens.
Software Revision Number Report:
Exhaust/Comp Enthalpy Module 8.04
Used With: Units with Comparative Enthalpy,
1. Pressing the NEXT key will scroll forward through the screens.
Software Revision Number Report:
Heat Module 1.00
Used With: Units with hydronic or electric heat
1. Pressing the NEXT key will scroll forward through the screens.
Software Revision Number Report:
Unit Human Interface 14.07
1. Pressing the NEXT key will scroll forward through the screens.
Software Revision Number Report:
Remote Human Interface (RHI) 11.04
Used With: Units with Remote Human Interface
Module installed.
1. Pressing the NEXT key will scroll forward through the screens.
Software Revision Number Report:
Ventilation Control Module (VCM) 1.12
Used With: Screen shown only if VCM Module
installed
1. Pressing the NEXT key will scroll forward through the screens.
Software Revision Number Report:
BAS Communications: xxxxxxx 13.00
Used With:Units with TCI, LCI or BCI.
xxxxxxx =
Comm3/4 (when TCI installed)
LonTalk (when LCI installed)
BACnet (when BCI installed)
1. Pressing the NEXT key will scroll forward through the screens.