Programming Guide

ManualsBrandsTrane ManualsSelf-Contained SystemsTrane Modular 20 to 35 Tons

Programming Status

20 PKG-SVP01D-EN

Temp Measured By Sensor Connected To

WSM ENT WATER TEMP INPUT 60.1 F

Used With: On water-cooled units only.

1. Press the NEXT key until the following screen is displayed.

Temp Measured By Sensor Connected To

WSM MIXED AIR TEMP INPUT 51.7 F

Used With: On water-cooled units only.

1. Press the NEXT key until the following screen is displayed.(if applicable)

Temp Measured By Sensor Connected To

WSM ENT COND WATER TEMP INPUT 64.9 F

Used With: On water-cooled units only.

1. Press the NEXT key until the following screen is displayed. (if applicable)

Temp Measured By Sensor Connected To

VCM MODULE AUX TEMP INPUT 50.0 F

Used With: Units with a VCM installed and O/A

preheater enabled.

1. Press the NEXT key until the following screen is displayed.

Compressor Module Ckt 1

Evap Temp 75.0 Sat Cond Temp 81.0 F

1. Pressing the NEXT key will scroll forward through the screens.

Compressor Module Ckt 2

Evap Temp 72.0 Sat Cond Temp 87.0 F

1. Pressing the NEXT key will scroll forward through the screens.

Compressor Module Ckt 3

Used With: SCWF/SIWF 42-80 tons or SCRF/SIRF

50-60 tons only.

Evap Temp 72.0 Sat Cond Temp 87.0 F

1. Pressing the NEXT key will scroll forward through the screens.

Compressor Module Ckt 4

Used With: SCWF/SIWF 65-80 tons.

Evap Temp 72.0 Sat Cond Temp 87.0 F

End of Submenu (NEXT) to Enter SETUP

1. Press the NEXT key until the following screen is displayed.

Misc Input Status Submenu

Press ENTER to View Data in This Submenu

1. Press the NEXT key until the following screen is displayed. (if applicable)

RTM Supply Airflow Proving Inut: FLOW

Possible Values: Flow, No Flow

1. Press the NEXT key until the following screen is displayed.

RTM Remote Min Position Pot Input 0%

Used With: Units when minimum position pot is

assigned to function.

Possible Values: 0-100%

1. Press the NEXT key until the following screen is displayed. (if applicable)

RTM Supply Air Pressure Input 2.1 IWC

Used With: Units with IGV or VFD, or units without

IGV or VFD and supply air pressure is present.

1. Press the NEXT key until the following screen is displayed.