Users Manual Part 1
Trouble Shooting
No lights are lighting on the Tower
• Check that the tower is plugged in and the switch is in an ON
position. If using the rechargeable battery, be sure it’s amply
charged. Also check that each player pad is turned on.
• Be sure the touch pads are placed within the optimal range: 5 to 50
feet from the tower
• If the touch pads are on a metal table or shielded by metal walls,
move them to some other surface
• Replace the 3AAA batteries in the touch pads. To conserve battery
life, be sure to turn PADs off when not in use.
• Check if Who’s First is in Random Mode. If so, toggle switch on
back of light tower to Standard Mode.
One light/touchpad is not working
• Reposition or Replace batteries: remove the battery cover from the
bottom of the touch pad. If batteries have popped out of place
during shipment, press them back into place; if the batteries are in
place but not working, try new batteries.
Please call if you have any questions.
Have Fun! 800-299-3770.
USB Interface
This version of Who’s First is equipped
with USB jack and cable in case you
want to use the Colored Team Touch
Pads with a software game of your
choosing. If you are creating your
own software interface, be aware that
each Touchpad corresponds with a
particular keyboard stroke. In fact,
you can test the interface by
plugging the cable from the Who’s First
light tower to your computer’s USB port.
Open MS Word, or any other program
you might type into. When you press
the Red touchpad, you should see the
number 1 appear on your screen.
Here are the keystrokes associated
with each color:
Red touchpad = 1
Orange touchpad = 2
Yellow touchpad = 3
Green touchpad = 4
Blue touchpad = 5
Magenta touchpad = 6
Reset touchpad = 7
NOTE: not all software game shows may
be set up this way. Some that have been
tested and shown to work include
WhaddayaKnow? by Trainers Warehouse and
Gameshow Pro by Learningware.
FCC COMPLIANCE INFORMATION for: WHO’S FIRST WIRELESS—6 TEAM RECEIVER, Model: WHOR8W
FCC ID : PKXWHOR8WT
This product was produced under the direction of Trainers Warehouse, 89 Washington Avenue, Natick MA 01760, 800.299.3770
WARNING!
Maximum is 5 volts!
DO NOT USE A DIFFERENT ADAPTER
TO RECHARGE!
To save battery turn off switch when not in use!
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with Part 15 of the FCC RF Rules. This
equipment must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with
antenna installation instructions and consider removing the no-collocation statement.
Caution!
Any changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.