User manual

Stopping magnets

The Car System stop magnets can be connected to the stopping

magnet output of the module. They always start operation

following the corresponding signal, but with a delay. Thus the

vehicles start half a second after green signal. The vehicles are

stopped a little before the signal turns red thus preventing the

vehicles from crossing on a red signal.

Inputs

The traffic sign can be controlled with the inputs. If none of the

inputs are active, the module will perform traffic control

automatically by its own internal timing.

‘A to RED’: Traffic signs ‘A’ will turn red. As long as the input is

active the module will retain red signal.

‘B to RED’: Similar to input ‘A’ but it will turn traffic signal ‘B’ red.

Use of inputs: Connect the inputs to the ‘red sign’ output of

another module, e.g. ‘red’ output of the railway crossing. As a

result, if the railway crossing is ‘red’ the traffic light will not turn

green on a wired direction.

Adjusting

The sequence timing can be adjusted by the DELAY ADJUST

potentiometer. This value only adjusts the period of full sequence,

not the internal timings.