User manual

3
For external control, connect the IN1 / IN2 input as a light bulb, or
any other load. These inputs are polarity insensitive and must be
supplied from external power source.
See Figure 1.
Connection of servo
The servo must be connected to the terminal pins as indicated in
the drawing. The BLACK/BROWN output is the common zero
(ground) point. By standard the RED cable is the power supply of
the servo, which is always 5 V. The WHITE/ORANGE output is the
control signal of the output.
Adjustment of end positions and moving speed
1. Switch on the module and check the proper connection of
the servo
2. Press the "PROG" button for at least 1 second
3. The "LED1" indicates the programming is applied to "Servo
1"
4. With UP/DOWN buttons, set the desired servo position as
the first position
5. Press the "PROG" button shortly
6. With UP/DOWN buttons, set the desired servo position as
the second position
7. Press the "PROG" button shortly
8. With UP/DOWN buttons, set the moving speed on the
selected servo
9. Press the "PROG" button shortly
10. The "LED2" indicates the programming will be applied to
"Servo 2"
11. Repeat the steps from 4 to 8 for the second servo
12. Press shortly the "PROG" button to exit from programming
mode