User manual

For external control, connect the IN1 / IN2 input as the light bulb, or

other load. These inputs are polarity insensitive, and need to be

supplied from external source. See Figure 1.

Connection of servo

The servo must be connected to the terminal pins as indicated in the

drawing. BLACK/BROWN output is the common zero (ground) point. By

standard the RED cable is the power supply of the servo, which is

always 5 V. The WHITE/ORANGE output is the control signal of the

output.

End positions and moving speed adjust

1. Power up the module and check the proper servo connection

2. Press the "PROG" button at least 1 second

3. The "LED1" indicates the programming is applied to "Servo 1"

4. With UP/DOWN buttons, set the desired servo position as the

first position

5. Press the "PROG" button shortly

6. With UP/DOWN buttons, set the desired servo position as the

second position

7. Press the "PROG" button shortly

8. With UP/DOWN buttons, set the moving speed on the selected

servo (Servo 1 or 2)

9. Press the "PROG" button shortly

10. The "LED2" indicates the programming will be applied to "Servo

11. Repeat the steps from 4 to 8 for the second servo

12. Press shortly the "PROG" button to exit from programming

mode