Use And Care Manual

Connection
It is recommended that you ensure that there is adequate height to install the unit. The trailer
should be high enough that, when the frame is level, there is enough space for the unit to be at
least one inch o the ground once attached to the bracket. If there is not enough space, adjust
the placement of the bracket on your trailer frame.
Place the mounting bracket and clamps onto the area of the frame you have designated and
secure with the four bolts. NOTE: While it is recommended that the bracket is installed with the
attachment point in the low position for stability reasons, the bracket can be ipped prior to
install if the space is required.
The Trailer Valet mounting bracket comes with a security bolt (part 7) that is an option to secure
the device. This will add stability if needed, but may slow the process of attaching and detaching
the unit from your trailer. If you choose to use it, the bolt slots through the back of the mounting
bracket and threads into the mounting joint.
Fit the mounting joint into the rotating coupler
on your Trailer Valet unit and secure with the
rotation/security pin. This joint replaces your
unit’s ball adapter.
Place the connection point of the mounting
joint into the mount bracket and fasten with
the included stow/clevis pin. Lastly, set the
cotter pin through the stow/clevis pin.
The XL Mounting Bracket is
compatible with the XL unit and
RVR units with ball tower.
Compatibility
XL RVR