Use and Care Manual

XL Mount Bracket Assembly
What’s in the Box:
1. Mount Bracket
2. Bracket Clamps
3. Bracket Bolts (x4)
4. Mounting Joint
5. Stow/Clevis Pin
6. Cotter Pin
7. Rotation/Security Pin
8. Security Bolt
Please note that use of the XL Mount Bracket decreases the unit’s incline rating. If you have any questions
concerning the use of your trailer Valet on a slope or incline, please contact us at
[phone] or Email us at [e-mail]
For warranty information, please refer to your XL user manual.
SETUP
When installing the Trailer Valet, the unit must be installed while the weight of the
trailer is supported by an existing jack. Having wheel chocks in place during connection
will also insure a safe install.
Raise the trailer tongue to where the coupler is about 16 inches off the ground to give
adequate space to attach the dolly.
WARNING! During installation, the Steering Handle must be secured to the safety clip to
ensure the brake is engaged at all times.
The mounting bracket has incremental bolt slots to fit a variety of trailer frames. Be sure
that you have at least 8 inches of free space for the mounting bracket to be fitted onto
your trailer frame.
WARNING! The mounting bracket is only to be installed on trailer tongues that are
rectangular in profile. Cylindrical frames are not compatible with the bracket as it will
rotate, allowing the trailer to drop.
1
2
3
4
6
8
5
7