Full Product Manual

OPERATING INSTRUCTIONS

OPERATING THE DEVICE

NOTE: If your trailer has built-in brakes, they must be disengaged prior to operation of the XL.

Consult your trailer manufacturer’s manual/instructions on temporary brake release. If this is

not available to you, please contact Trailer Valet Customer Support through phone or email for

assistance.

1) When you’re getting ready to operate the device, make sure you have one hand rmly gripped

on the brake, and the other hand rmly gripped on the drill/driver.

2) Slowly lift the Steering Handle until the brake is disengaged and begin cranking. The Steering

Handle must be held up rmly at all times when moving the trailer.

NOTE: Hold the drill/driver rmly when engaging. The drill will have high initial torque if the drill

trigger is pulled rather than squeezed. Begin to move the trailer as slowly as you are capable and

carefully increase the power up to an appropriate speed when using the Drill Attachment.

NOTE: It is important that you steer the device only when you are cranking and the trailer is

moving. Attempting to turn the Steering/Brake Handle at a dead stop will place excessive stress

on a single tire.

NOTE: When attempting to make sharp turns (E.G. 90° rotation) from a stationary position, crank

the XL back and forth while turning until the unit is in the desired position. Then, proceed to

make the turn.

WARNING: DO NOT use the XL on slopes and inclines exceeding a strict maximum of 10

degrees on a paved/concrete surface. This rating is subject to factors including, but not limited

to, alternate surfaces, weight distribution, change in weight capacity, and use on multi-axle

trailers. DO NOT pull up or push down an incline. The unit must always be on the lower end of

any incline. If you have any questions concerning the use of your XL on a slope or incline, please

NOTE: Use of power drill is inadvisable for movement upon any incline.

REMOVING THE DEVICE

1) Remove the drill/drive handle.

2) Lower the jack until the XL is above the ground.

3) To detach the Telescoping Arm, remove the Security Pins from the Jack Clamp and the Base

Bracket. The Jack Clamp can optionally be left secured to the jack for future use.

4) Loosen the Locking Nut and release the latch on the coupler.