Full Product Manual

Lower the trailer gradually unl the exisng jack is
above ground and the trailer is completely supported
by the Trailer Valet.
Step 4: TESTING THE ASSEMBLY
1)
NOTE: Keeping the trailer jack close to the ground prevents
serious damages from occuring due to unexpected failures.
unable to hold the weight, lower the jack and remove the
device to check air pressure.
1)
WARNING
!
Always ensure the operator and bystanders
are aware of the stability of the load.
Step 5: ATTACHING DRIVER
Operating Instructions
8
1) Using the chuck of your drill/driver, connect to the
drill socket
If you are using a cordless drill, be sure your
WARNING
!
2) Secure the chuck of your drill around the drill socket
The drill can loosen and cause injury.
WARNING
!
3)
4) Align and insert the drill socket to the low gear
If using a corded drill/driver, verify that the power
on the Trailer Valet or moving vehicle will not damage
the cords or that the cords cannot be stepped on,
tripped over, or otherwise subjected to damage.
Hold the drill/driver firmly when engaging.
WARNING
!
1)
sure you have one hand firmly gripped on the brake, and
the other hand firmly gripped on the drill/driver.
disengaged and start cranking.
2)
NOTE: It is important that you steer the device only when you
steering handle at a dead stop will cause the gears to fall out
of alignment.
1) Remove the drill/drive handle.
2)
Loosen the lock nut and release the latch on the coupler. 3)
Step 6: OPERATING THE DEVICE
Step 7: REMOVING THE DEVICE
SCAN THIS QR CODE to see
a video showing Steps 2
through 4 if you need a
visual guide to install your
Trailer Valet.
SCAN THIS QR CODE to see
a video on how to use your
drill aachment to move
your Trailer Valet!
SCAN THIS QR CODE to see a
video on how to detatch your
Trailer Valet.