Full Product Manual

secure using the rotaon pin.
res are damaged due to its failure to hold air. Check re
pressure before using the Trailer Valet for the first me,
since air pressure might have been lost in transit.
Knowing the proper dollying techniques can help
keep you and others around you safe. In this guide,
you are shown the basic fundamentals for effecve
dollying. However, it is up to you to analyze the
situaon and make the decisions necessary for the
proper use of your Trailer Valet. Apply your
knowledge of your Trailer Valet and the basic
fundamentals you have pracced to adjust your
techniques to each unique situaon.
Only use the ball included in the box when
Operating Instructions
Things you will need to operate your Trailer Valet:
Trailer Valet
Crank Handle or Drill Socket
Items sold separately:
Standard Drill/Driver (minimum drive torque
Upon removing the dolly from packaging, it is very
important to thoroughly inspect all parts of the system
before using the device. Any part that is missing or
damaged must be immediately replaced. Contact
Trailer Valet Customer Service at 1-626-400-6299.
1)
2)
WARNING
!
Step 1: REMOVE THE TRAILE VALET FROM THE BOX AND
INSTALL
THE BALL ATTACHMENT.
1)
the Tightening Tool from the box.
2)
Step 2: ADJUSTING THE TRAILER HEIGHT
1) Raise the trailer tongue to where the coupler is about
14 inches off the ground (the same height of the ball
when the Trailer Valet is upright).
Tires must be above 75 psi (pounds per
square inch) prior to use. Do not use the device if the
7
2)
Slip the ball into the coupler and lock the ball with the
coupler latch.
the coupler.
3)
Raise the trailer slightly so that the device hangs from the
coupler and the wheels on the Trailer Valet are above
4)
Using the Tightening Tool, turn the locking nut counter
NOTE: To ensure that the locking nut is securly fastened to
locking nut remains flat against the coupler.
the coupler will cause the ball to slip out of the coupler,
and the trailer tongue to fall to the ground upon use.
WARNING
!
1) Slide the Trailer Valet directly under the coupler.
The steering handle must be secured to the
WARNING
!
Step 3: ATTACHING THE BALL TO THE COUPLER
SCAN THIS QR CODE to
see a video on what to
expect when unboxing
your Trailer Valet!
WARNING
!