Instructions / Assembly

Assembly
7
REPLACING THE REMOTE CONTROL
BATTERIES
1. Loosen the 4 screws on the remote’s
back panel and remove.
2. Replace the old batteries with two new
AA (1.5V) batteries.
Remember to protect the environment
when disposing of batteries – do not
dispose with ordinary household waste.
ATTACH WITH COUPLER SET:
1. If the Coupling Plate is not already installed
with the Ball Base, detach the ball from the
Base, slip the Coupling Plate under the ball,
and reinsert into the Base. Secure tightly.
2. Place the Ball Base into the Base tower
and secure with included pin. Then secure
the Ball Base Tower into the slot on top of the
RVR in place of the Mount Bracket Tower.
3. Raise the trailer tongue above the height
of the Hitch Ball in order to slip the ball into
the coupler and lock the with the coupler latch.
4. Using the Spanner Wrench, turn the
Locking Nut counter clockwise until the nut

WARNING! Failure to tighten the Locking
Nut against the coupler may cause the ball
to slip out of the coupler.
CHARGING THE RVR
To charge the RVR battery, connect the
charger to the RVR by placing the charging
plug in the outlet on the back end cover.
Connect the charger to an outlet with the

The battery charger displays a constant
red light while charging is in progress.
Completion of battery charging is
indicated by a constant green light.
ATTACH WITH MOUNT BRACKET:
1. When mounting the RVR onto your
trailer frame, adjust the front height using
your trailer jack when either detaching or
stowing the jack.
2. Fit the Mount Bracket Tower into the slot
on the top of the RVR and Secure with the
four included screws.
3. The Mount Bracket Tower on the RVR

Mount Bracket. (See Figure)
4. After the tower is slotted, use the
factory- provided cotter ring to lock the
RVR to the frame Mount Bracket.
MB Tower Slot & Cotter Pin Hole
Charging
Outlet