JACKS OPERATING MANUAL
OPERATING MANUAL WARNING Carefully read and understand all the instructions before connecting your new Blackout Series Jack. Failure to follow these guidelines may result in serious injury to persons and property for which Trailer Valet will not be held liable. Do not allow persons to operate or assemble this jack until they have read this manual and have developed a thorough understanding of how the jack works. SAVE THESE INSTRUCTIONS TABLE OF CONTENTS WARNING & TABLE OF CONTENTS........................
IMPORTANT SAFETY INFORMATION Failure to heed these markings may result in personal injury and/or property damage: 1. DO NOT leave your trailer free standing without the use of wheel chocks. 2. DO NOT submerge the jack in water (salt or fresh) or leave it in water for prolonged periods, since this can damage the gears and erode lubricants. 3. Carefully read all instructions.
Specifications The Blackout Series Jacks is a line of manual hand-crank trailer jacks that have the versatility to be powered using any standard 18-24V drill and a Trailer Valet Drill Attachment. The line comes in two weight capacities with either side or center mount options. Each product comes standard with a hand crank, drill attachment, and static footplate.
Overview Upon removing items from packaging, it is very important to thoroughly inspect all parts of the system before using the device. Any part that is missing or damaged must be immediately replaced. Contact Trailer Valet Customer Service at 1-844-846-9344 or Support@TrailerValet.
assembly Prior to install, raise the trailer tongue until you have adequate space to attach the jack. The unit must be attached while the weight of the trailer is supported by an existing support or tow vehicle. Having wheel chocks in place during connection will insure a safe install. It is recommended that you make sure the jack will have necessary clearance from the ground to operate and rotate into the stow position.
assembly CIRCLE FRAME CENTER MOUNT INSTALLATION SWIVEL MOUNT INSTALLATION STEP 2. You can now fit the jack to the coupler. Bolt sizes are specific to your coupler and are not included with your Blackout Series Jack purchase. Alternatively, the center jack can also be welded for a more permanent attachment to the trailer. WARNING The mount bracket is only to be installed on trailer frames that are rectangular in profile. Cylindrical frames are not compatible with the mount bracket.
OPERATING INSTRUCTIONS ATTACHING DRIVER Option 1: Manual Operation Attach the Drive Handle to the Driveshaft located at the top of the unit. Turning the handle clockwise will extend the jack. Turning the handle counter-clockwise will retract the Jack. Option 2: Drill Adapter The Drill Adapter can be used with any standard 18 to 24 volt, ½ inch chuck, consumer drill. Corded drills and impact drills are not recommended.
LIMITED MANUFACTURER’S WARRANTY SuperTech S Corp warrants for one year from the purchase date that the product will be in working condition and will be free from manufacturing defects, provided that installation and use of the product is in accordance with product instructions. This warranty is only made to the original consumer purchaser and is non-transferable. ALL OTHER WARRANTIES IMPLIED OR EXPRESSED ARE HEREBY DISCLAIMED. THIS WARRANTY DOES NOT COVER: 1.
Copyright 2020 by Supertech S. Corporation. All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Supertech S. Corporation. For further information or if you have any questions, please contact: SUPERTECH S. CORP. 17970 Ajax Circle Industry, CA 91748 Customer Service: (844) 846-9344 Email: support@trailervalet.com W W W.TR AILERVALE T.
