User's Manual

5
Replacing Batteries in the Backup Camera
The batteries in the QuickVu™ All-Digital Wireless Backup Camera should last several months in normal use
2
.
As the batteries grow weak, the monitor will display a low-battery indicator. When you see this indicator,
replace the batteries promptly, to ensure uninterrupted use of your backup camera.
The camera uses two AA batteries. For adequate power and battery life, we recommend using high-quality
lithium batteries, such as Energizer® Ultimate Lithium batteries.
To replace the batteries, first remove the camera from your vehicle. Then remove the six screws that secure
the battery compartment cover. Remove the cover and note the location of the positive end of the
batteries. Remove the old batteries
3
, and insert the new batteries, making sure that the positive end of
each battery is in the correct location
4
.
Note that the batteries fit very snugly. Insert the negative end of the battery in first. Be careful not to use
excessive force as you may damage the camera’s circuitry.
With the batteries in place, replace the cover, making sure that the O-ring seals are in place around the
cover and on each of the six screws. Be careful not to over-tighten the six screws. Re-mount the camera on
your vehicle.
2
Normal use would be approximately 4 uses per day, 30 seconds per use. For example, you back out of
your garage and drive to work, back out of parking space to go to lunch, back out of parking space to return
to work, and then back out of parking space to drive home. Prolonged extremes in temperature, additional
usage, and battery quality will all affect actual battery life.
3
Be sure to dispose of used batteries properly.
4
If you are unsure, refer to the diagram on the sticker inside the battery compartment.