Product Manual

CAUTION
NO PERSON SHOULD PLACE ANY
PORTION OF THEIR BODY UNDER
A CARAVAN / TRAILER THAT IS
SUPPORTED ONLY BY A JACK.
USE VEHICLE SUPPORT STANDS
HOW TO CONVERT HYDRAULIC JOCKEY WHEEL INTO A JACK
1. You MUST REMOVE wheel and fit base plate to use as a jack.
2. Fit lifting clamp to outer shaft cover (Between or over lugs) opposite side of
release valve and jack handle linkage.
3. Make sure lifting clamp handle is done up tight.
4. Position jack along side the vehicle so that the slot in saddle is centered
below the Trail-A-Mate engagement fitting on caravan.
5. Make sure release valve is tightened clock-wise and pump handle until
slot in saddle is locked into the Trail-A-Mate engagement fitting.
6. Continue to raise jack to desired height.
7. When finished, remove support stands and then slowly turn release valve
counter-clockwise to lower vehicle.
Minimum Height of Trail-A-Mate: 145mm
Maximum Height of Trail-A-Mate: 780mm
Maximum Lifting Range: 380mm
Working Load Limit: 1000kg