Installation Guide

Installation Instructions
Self-Stick Luxury Vinyl Tile
For Assistance, Call: 1-877-527-0313
www.HomeDepot.com
Product Description
12 in. x 24 in. Tile, 10 Tiles, 20 sq. ft. Per Box
6 in. x 36 in. Plank, 24 Planks, 36 sq. ft. Per Box
Grade Levels
Above Grade / On Grade
Below Grade
Installation Method
Peel and Stick
HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Accessories
Pictures are for general illustrative purposes only. Actual products may differ from pictures.
□ Clean the oor.
□ Install or reinstall all wall trim pieces. Nail them through the wall, but not to the suboor to avoid restricting the expansion gap.
□ Install transition trim pieces. Nail them to the suboor, not the ooring.
□ At doorways, transitions should be used to protect the edges of the oor and to provide a decorative transition from one oor type to another.
□ If the oor is to be covered, use a breathable material such as cardboard. Do not cover with plastic.
T-Molding: Used to create a transition between oor coverings of similar heights or to cover an expansion gap.
T-MOLDING
FLOORING
FLOORING
Stair Nose: Used in conjunction with ooring installed on stair steps or nished edges of a higher level oor
like in a sunken living room.
FLOORING STAIR NOSE
RISER
STAIR TREAD
Hard Surface Reducer: Used to transition to another hard surface ooring of different heights such as tile,
vinyl, or concrete.
HARD SURFACE
REDUCER
RESILIENT
FLOOR
FLOORING
Quarter Round: Used to cover the expansion space between the wall base and your ooring. It can also
be used to make smooth transitions between the oor and cabinetry. It can be used with or without wall base
molding. Ensure you nail the quarter round to the wall and not the ooring, as shown.
FLOORING
QUARTER ROUND
WALL
Care and Maintenance
DAILY MAINTENANCE
□ Sweep, dust, damp mop, or vacuum your oor regularly to remove any particles that could cause abrasion or scratch your oor.
CAUTION: Vacuums with a beater bar or power rotary brush head can damage a oor and should never be used.
□ Use a damp mop to remove spots and soil. Use any high-quality, pH-neutral vinyl cleaner. Alternatively, use a non-rinsing, biodegradable cleaner that leaves no residue or haze.
□ For lightly soiled area, clean with distilled water.
□ HINT: For best results, clean the oor in the same direction of the tiles. When the cleaning cloth/mop becomes soiled, rinse or replace it with a clean one. Following up with a clean, dry cloth will remove residual streak marks
and spots.
□ Do NOT leave any amount of liquids (water, juice, soft drinks, spills, etc.) on the oor. Clean any wet spots immediately.
□ Do NOT use a wet mop or douse the oor with water or liquid cleaners. Liquid can seep between the cracks and cause moisture damage.
□ Do NOT use any cleaning agents containing wax, oil or polish. Left over residue will form a dull lm.
□ Do NOT use steel wool or scouring powder which will scratch the oor.
□ Do NOT use any dust cleaners, as they may cause your oor to become slick or damage the nish.
□ Avoid spills of paints, dyes, or harsh chemicals.
□ Avoid long term exposure to direct sunlight. High temperatures directly on the oor may cause the adhesive to reactivate and release from the suboor. Use window treatments or UV tinting on windows.
BRANDED OR OFF-THE-SHELF FLOOR CARE PRODUCTS
If none of the above are effective and you choose to use a store bought product, test the product in a non-conspicuous area (i.e., closet, corner, or scrap pieces) for potential adverse side effects.
PREVENTATIVE MAINTENANCE
□ Protect your oor when using a dolly for moving furniture or appliances. Protective sheets and/or plywood may be needed. Never slide or roll heavy furniture or appliances across the oor.
□ Use at oor protectors (nylon or felt) on all furniture legs. Clean protectors periodically to remove grit that may become embedded and cause scratching.
□ Avoid excessive exposure to water from being tracked in during periods of inclement weather.
□ Minimize abrasive material and dirt by placing mats on both sides of exterior doors and by using area rugs in high-trafc areas
□ Rearrange furniture and rugs periodically to avoid uneven color and shade changes from light exposure.
□ Use protective mats beneath rolling chairs and keep furniture casters clean.
□ Use NON-RUBBER backed mats at all entrances to reduce the walk-off residue from asphalt driveways as well as prevent dirt and grit from being tracked onto your oor. Rubber backed mats can discolor your oor.
□ We recommend the use of a hard surface (non-studded), non-rubber chair mat to protect your oor from ofce chairs with casters. Light, rolling furniture should be outtted with broad-surface, non-staining casters that have
been engineered for hard surface oors. Such casters should be a minimum of 1 in. (2.5 cm) wide and at least 2 in. (5.1 cm) in diameter.
□ Keep pets’ nails trimmed.
□ Remove shoes with cleats, spikes or exceptionally pointy heels before walking on the oor.
TREATING STAINS, SPILLS, AND SCUFFS
Follow the remedies in order. Unless instructed otherwise, use a clean, white cloth or towel with products recommended for our LVT ooring. Always rinse the affected area with clean water after treatment.
□ For most stains and spills such as acids, alkalis, foods, and rust: First, remove as much of the spill as possible. Scrub the area with a full strength cleaner. Rub the area with a 10/1 dilution of water/liquid bleach. Rub the area
with isopropyl alcohol. If rust stain does not respond, use lemon juice or a cream of tartar solution.
□ For paint and solvent spills such as dry cleaning fluids, paints, nail polish, and wood stains: If the substance is dry, gently peel it from the oor. Avoid sharp instruments that could scratch the oor. Scrub the area with a non-
abrasive cleaner. Rub lightly with odorless mineral spirits or paint thinner.
NOTE: Do not use acetone or nail polish remover!
□ For substances that do not wipe up such as adhesives, chewing gum, oil, and grease: First, remove as much solid material as possible. Carefully remove excess with a spoon or ngernail. Scrub the area with non-abrasive
cleaner. Rub lightly with odorless mineral spirits, isopropyl alcohol or lighter uids.
□ For scuffs and smudges: Rub the scuff with your ngertip. The friction from the rubbing will remove rubber. Scrub the area with non-abrasive cleaner. Rub lightly with isopropyl alcohol or lighter uid.
CLIMATE MAINTENANCE
□ Care should be taken to control humidity levels within the 35% - 85% range to avoid excessive movement within the oor.
□ Dry Climates: A humidier is recommended to maintain humidity levels. Wood stoves and electric heat tend to create very dry conditions during the winter months this also will cause shrinkage in ooring.
□ Humid, Wet Climates: By using an air conditioner, heater, or dehumidier proper humidity levels can be maintained to prevent excessive expansion due to high moisture content.
FLOOR REPAIR
□ Very deep scratches may require the replacement of the tiles.
USE OF FINISHES
□ If a nish coat is desired, use a matte nish designed for vinyl ooring only. Avoid use of waxes.
□ If a nish is applied this will become part of the regular maintenance and may require periodic stripping and reapplication of the nish.