Use and Care Manual

Allure Ultra with SimpleFit® End Joint

Correct

 Cutting through the Simplefit®

Locking Strip first before cutting

across a full plank/tile

 Locking long tongue into groove and

slide at a low angle until first inch of

the SimpleFit® Locking Strip touches

the short groove edge of previously

installed plank/tile

 Pressing the SimpleFit® Locking

Strip joint into place using your finger

until lock is completely engaged

Incorrect

 Removing the white SimpleFit®

Locking Strip

 Overlapping the SimpleFit® Locking

Strip over the previously installed

plank/tile

 Proceeding with the installation if the

SimpleFit® Locking Strip is damaged

during locking or tapping. Always

remove and replace using a new piece

PAGE 1
Allure Ultra with SimpleFit® End Joint Correct  Cutting through the Simplefit® Incorrect  Removing the white SimpleFit® Locking Strip  Overlapping the SimpleFit® Locking Strip over the previously installed plank/tile  Proceeding with the installation if the SimpleFit® Locking Strip is damaged during locking or tapping.
PAGE 2
Incorrect Correct  Tapping the top of SimpleFit® Locking Strip using a light rubber mallet to ensure the plank/tile is resting flat on the floor with no gaps  Using a tapping block down the long side of the plank/tile to ensure a gapfree installation  Using a regular hammer to tap in the SimpleFit® Locking Strip as this will damage the product  Tapping the product in from the short side as this will cause damage to the Simplefit® Locking Strip If you have any problems or questions, please call