Manual

traegergrills.com | 13
INITIAL FIRING INSTRUCTIONS
To be used on initial ring or anytime the grill runs out of pellets. In order to ensure
proper operation of the grill, you must rst prime the pellet hopper’s auger by allowing the auger
tube to be “charged” with pellets.
1
Remove the grill grate, cast-iron
griddle, and grease drip tray from
the inside of the grill.
2
With the Main Power switch in the
OFF (O) position, plug the power cord
into an appropriate grounded/earthed
electrical outlet. Once the grill is
plugged in, ip the Main Power
switch to ON (I).
3
Make sure there are no foreign objects
in the auger. With the grill in Idle
mode, press and hold the UP and
IGNITE buttons simultaneously. The
display will ash “Pri” and the auger
will begin priming.
4
Fill the hopper with your choice of
TRAEGER
®
BRAND HARDWOOD
PELLETS. The auger tube should take
approximately 2 minutes to ll with
pellets and begin dispensing into the
repot.
WARNING! Use ONLY TRAEGER
®
BRAND HARDWOOD PELLETS. Never
use heating fuel pellets in the grill.
NOTE: Once you turn on your grill, it will enter Idle mode,
and the display’s dashed border will pulse. This indicates
your grill is awaiting a command, and is not actively
operating. The grill MUST be in Idle mode to prime
the auger.
T01364_Ranger_OM_EN.indd 13 9/9/19 8:59 AM