Use and Care Manual

14
375Smoke
Shut Down
Cycle
High
Power
OFF
ON
F
225
180
325
275
375Smoke
Shut Down
Cycle
High
Power
OFF
ON
F
225
180
325
275
375Smoke
Shut Down
Cycle
High
Power
OFF
ON
NOTE: If the procedure is not successful, see “FREQUENTLY ASKED QUESTIONS” on page 18 for
troubleshooting tips or contact Traeger's VIP-365 Customer Service (see page 22) to help diagnose
the problem.
3
WARNING! Remove all unburned
pellets and ash from inside and
around the repot. (See instructions
for proper handling and disposal of
ash on page 17.)
4
Plug power cord into an appropriate
grounded electrical outlet and restart
the grill. Pellets should fall into the
repot and the hot rod should begin
to heat (it will start to turn red).
CAUTION! Do not touch the hot rod.
5
When ames start to come out of the
repot, turn the switch OFF (O). Let
the grill cool down. Now you’re ready
to place the heat bafe, grease drain
pan, and porcelain-coated grill grate
back into the grill.
6
With the door open, turn the switch
ON (I) and the temperature dial to
SMOKE. In about 2 minutes, the
pellets will ignite and whitish-gray
smoke will come out of the grill. After
the pellets have ignited, close the door
and turn the temperature dial to any
cooking setting desired.
REIGNITING YOUR GRILL (cont.)
66104_Eastwood_UCG_v3.indd 14 10/25/16 3:15 PM