Installation Guide

ManualsBrandsTraeger ManualsGrill Replacement PartsDigital Pro Controller

DOC260 REV A

Handcrafted Wood Pellet Grills

Pro Pid Digital Thermostat Kit With Meat

Probes Installation Manual

Step-By-Step Instructions for Installing Digital Thermostat Kits in

Traeger Wood Pellet Grills

All Models with Digital Controls

Summary of content (4 pages)

PAGE 1
Handcrafted Wood Pellet Grills Pro Pid Digital Thermostat Kit With Meat Probes Installation Manual Step-By-Step Instructions for Installing Digital Thermostat Kits in Traeger Wood Pellet Grills All Models with Digital Controls DOC260 REV A
PAGE 2
INTRODUCTION When you un-box the Digital Thermostat Kit, make sure you have, and can identify all of the following parts: (1) Pro Pid Controller With Meat Probes (1) 7” RTD - Temperature Sensor Rod (1) Screw (1/2” long) (1) Lock Nut (1) Meat probe 1 (1) Meat probe 2 (1) Silicone Grommet (4) Wire ties The easy installation process includes: 1) Removing the existing digital control. 2) Installing the RTD. 3) Wiring and Mounting the Digital Thermostat Control.
PAGE 3
INSTALLATION INSTRUCTIONS REMOVING THE EXISTING SMOKER CONTROL: 1) Make sure the Switch/Dial is in the OFF position. Disconnect the Power Cord from the electrical outlet. 2) Review the Digital Control Wiring Diagram to familiarize yourself with the color coding of the wiring connections. Disconnect the wiring from the Smoker Control by separating the 4 Molex Connectors found on the underside of the Pellet hopper. 3) Remove the two screws securing the Smoker Control to the Pellet Hopper.
PAGE 4
1) Locate the Green Terminal Block on the back of the Digital Control in the upper right corner. Using a small screwdriver, loosen the two screws to open the clamping jaws enough to insert the RTD Wire ends. 2) Insert a bare wire end on one of the RTD Wires into the clamping jaws on one post of the Terminal Block. Tighten the screw to securely attach the wire. Do not over tighten. Repeat this process on the remaining wire. The RTD Wires may be connected to the Terminal Block in any combination.