Owner manual

ManualsBrandsTracRac ManualsCarIM Toolbox Mount Kits

TracRac Inc. 994 Jefferson St. Fall River, MA 02721 l 800-501-1578

Instruction Manual

41000 - Toolbox Mount Kit For TracONE•

34000 - Tacoma Mount Kit•

41500 - Tacoma Mount Kit with Toolbox Mount•

Installation Instructions:

TracRac

994 Jefferson St.

Fall River MA

800-501-1587

www.tracrac.com

Summary of content (4 pages)

PAGE 1
Installation Instructions: • 41000 - Toolbox Mount Kit For TracONE • 34000 - Tacoma Mount Kit • 41500 - Tacoma Mount Kit with Toolbox Mount TracRac 994 Jefferson St. Fall River MA 800-501-1587 www.tracrac.com TracRac Inc. 994 Jefferson St.
PAGE 2
Toolbox Installation - 41000 1. Remove the front 2 clamps from either side of the front rack and replace with TB Front Clamps (Figure 1) 2. Take one of the TB Rear Mounts and thread a 3/8”-16 HHCS in through the bottom of the clamp. 3. Take the C-Channel Clamp Foot and place it on top of the 3/8” HHCS (Figure 2) 4. Repeat Steps 2 & 3 for the opposite TB Rear Mount. 5.
PAGE 3
Toyota Tacoma Mount Installation - 34000 Tacoma Installation (Clamp Set) 1. Remove the plastic end-caps from the factory installed rails, front and back. 2. Take the Tacoma mount clamp and partially thread a 3/8”-16 hex head cap screw through the tapped hole located on the bottom of the clamp. 3. Slide two clamps into each factory installed rail from the back end of the truck and replace the rear end-caps. 4.
PAGE 4
Toyota Tacoma Toolbox Installation - 41500 1. Remove the plastic end-caps from the factory installed rails, front and back. 2. Take the Tacoma Tool Box Mount Clamp and partially thread a 3/8”-16 hex head cap screw through the tapped hole located on the bottom of the clamp. 3. Slide two clamps into each factory installed rail from the back end of the truck and replace the rear end-caps. 4. Slide three clamps into each factory installed rail from the front end of the truck and replace the front end-caps. 5.