Instruction Manual

T-Rac Pro
INSTRUCTION MANUAL
7
TracRac Inc. 994 Jefferson Street, Fall River, MA 02721-4893 • 508-677-4130
7. Push the clamp assembly outboard against the sidewall, and lightly tighten the cap screws
.
8. Once a set of corners has been loosely tightened to the truck sidewall, center the crossbar left to right.
Crossbar should
fit flat on the saddle plates
,
fit flat on the saddle plates, fit flat on the saddle plates
(fig. 1)
then tighten the saddle plate T-bolt nuts
(fig. 1) then tighten the saddle plate T-bolt nuts (fig. 1)
(Torque T-bolt nuts to 240 in-lbs.)
.
(Torque T-bolt nuts to 240 in-lbs.). (Torque T-bolt nuts to 240 in-lbs.)
Next tighten corner brace fasteners to 240 in-lbs. Fully tighten cap screws on base rail clamps
(Torque to 120-150 in-lbs)
.
(Torque to 120-150 in-lbs).(Torque to 120-150 in-lbs)
Figure 5. Clamp Mounting Detail