Installation Guide
TracRac Inc. 994 Jeerson St. Fall River, MA 02721 l 800-501-1578
Instruction Manual
TIEDOWNS AND END CAPS
1. Remove the plastic crossbar tiedowns (Item
20) and T-bolts (Item 21) from the packaging.
Partially thread the T-bolt through the hole in the
bottom of the tiedown. See Image A. Slide the
unit into the top track of the crossbar and twist
the tiedown until securely in place.
2. Next locate the aluminum crossbar end caps
(Item 2). Making sure the at side of the end cap is
facing towards the ground, See Image B insert the
end cap into the end of the crossbar and secure
using the socket head cap screw (Item 15). See
Image C.
Image A
Image B
Image C
Part 3 - Accessories & Hardware
INSTALL NOTE:
Now your ready to put the rack onto the truck. If your
alone, we recommend that you place the racks into
the trucks bed before placing into position.
INSTALLING THE RACKS
1. Take the rounded shims (Item 5) and place them
on the sidewalls of you truck approximately where
the uprights will sit.
2. Place the front uprights on top of the rounded shims
making sure that the rubber shims are completely
under the bases.
3. Place the rear uprights on top of the rounded shims
making sure that the rubber shims are completely
under the bases.
4. When the racks are in place, adjust the uprights
outwards towards the inner lip of the truck bed so
that the l-rail of the base is as close to the truck bed
as possible.
Note: Due to the tapper in many trucks beds, the
l-rail on the base may not but completely against
the side of the truck bed. This gap is normal and
will not affect the performance of the rack.
Flat side down