Installation Guide
TracRac Inc. 994 Jeerson St. Fall River, MA 02721 l 800-501-1578
Instruction Manual
Step 1
Part 1 - Uprights
Note:
Both
surfaces
must be
parallel
with each
other
UPRIGHT ASSEMBLY
1. Insert the top (opposite the decal) of the upright (Item
10) into the Saddle (Item 3). Make sure that the smaller
loft is facing the side with the decal. (see image)
2. Bolt the saddle through the top by using two 3/8”-16
FHCS (Item 12) and tighten using a 7/32” Allen Key (or
7/32” Allen Drive Bit). Torque the 3/8” -16 FHCS to 32 ft-
lbs.
3. NOTE: We recommend threading both at head cap
screws initially by hand to ensure that you don’t cross
thread the bolt. The bolt may seem dicult to thread -
This is normal and will ensure proper rack performance.
When tightening the 3/8” FHCS ensure that the Allen Key
is fully seated in the bolt so that it will not strip.
4. Now take the upright and saddle and bolt it to the
modular base (Item 11 or 9). When bolting the base to the
upright make sure that the decal is facing the larger loft
of the base (opposite the L shape-lip of the base)
5. Repeat Steps 1-4 for the remaining three uprights.
12
3
10
11/9
Large
Loft
Large
Loft
Small
Loft
Small
Loft