Datasheet

ManualsBrandsTRACOPOWER ManualsRack & DIN Rail Mount PSUsRail mounted PSU (DIN) 24 Vdc 15 A 180 W 1 x

http://www.tracopower.com Page 5 of 11

Industrial Power Supplies

TSP-WR Series 180–600 Watt

TSP–BFM24 Buffer Module

The TSP-BFM24 Buffer Module will hold the output voltage of a 24VDC power sup-

ply after brown outs or voltage dips of up to ten full 50Hz cycles. During this buffer

period no deterioration of the 24VDC output voltage will occur. For many applica-

tions this buffer module is an ideal and cost effective alternative to a battery based

backup system. The buffer module consists of a large bank of capacitors. When the

power supply is switched on, the buffer capacitors will be charged. This will take

approximately 30 second and an opto-coupler signal is indicating the „READY“

condition. When a power fail occurs, the capacitor bank is discharged, maintaining

the output of the buffer module at its nominal voltage. This condition is indicated by

an „POWER FAIL“ signal. The hold up time is typically 200ms at 25A and 4 seconds

typically at 1,2A. After 4 seconds the buffer device will switch off the output voltage.

The operation modes of the module are indicated by a LED on the front panel also.

The big advantage of this buffer solution is, that it is fully maintenance free and its

storage capability does not deteriorate over the live time of the product.

Order code

(includes terminal plugs)

Operating Voltage

Range

Buffer Time Output Power

max.

TSP-BFM24

24...28VDC

200ms typ. @ 25A max.

4.0 s max. @1.2A

600 W

Models

Function Diagram Connector Positions

TSP

Load

Inhibit

Volt adjust

Voltage

Detection

Voltage

Detection

Discharge

Charge

Active

Ready

J2.2

J2.1

J1.1

J1.2

J1.3

J1.4

J2.4

J2.3

J2.6

J2.5

Specifications

Operating temperature – 25°C...+70°C max. (–13°F...+158°F)

derating above 40°C (104°F): 1.5%/K

Electromagnetic compatibility in correspondence to connected units (no internal

switching device)

Buffer voltage adjustable, >1V below input voltage, min. 22VDC

Charging 0.6A max. / 30s max.

Status signals Buffer Active , Buffer Ready (optocoupler output)

and dual colour LED for status indication

Inhibit optocoupler input: 35V max. <5mA

Dimensions see page 8

Installation instructions