Datasheet

Page 3 of 3
Specifications can be changed without notice! Make sure you are using the latest documentation, downloadable at www.tracopower.com
www.tracopower.com
DC/DC Converters
TMR 6WI Series 6 Watt
Outline Dimensions
Pin Single Dual
1
–Vin (GND) –Vin (GND)
2
+Vin (Vcc) +Vin (Vcc)
3
Remote On/Off Remote On/Off
5
No function No function
6
+Vout +Vout
7
–Vout Common
8
No function –Vout
Pin-Out
Rev. July 18. 2014
General Specifications
Reliability, calculated MTBF (MIL-HDBK-217F, at +25°C, ground benign) >2.9 Mio h
Isolation voltage (60sec.) – Input/Output 1500 VDC
Isolation capacitance – Input/Output 50 pF max.
Isolation resistance – Input/Output (500 VDC) >1 GOhm
Switching frequency 522 kHz min. (PWM)
Remote On/Off – On: open or high impedance
– Off: 2...4 mA current applied via 1KOhm resistor
– Off stand by input current 1.0 mA typ.
Safety standards IEC/EN 60950-1, UL 60950-1
Altitude during operation 4‘000 m max. (13‘120 f t ) approved
Environmental compliance – Reach www.tracopower.com/overview/tmr6wi
– RoHS RoHS directive 2011/65/EU
Physical Specifications
Casing material non-conductive plastic
Potting material silicone, (UL 94V-0 rated)
Weight 4.8 g ( 0.17oz )
Dimensions in [mm], () = Inch
Tolerances: ±0.5 (±0.02)
Pin pich tolerances: ±0.25 (±0.01)
Application note: www.tracopower.com/products/tmr6wi-application.pdf
pendin g
bottom view
3.2
(0.13)
0.5 (0.02)
0.25
(0.01)
2.0
21.8
5.08
3 x 2.54
0.5
(0.02)
11.2
(0.44)
(3 x 0.1)(0.08) (0.2)
4.1
2 x 2.54
(2 x 0.1)
(0.86)
(0.16)
9.1
(0.36)
1235678