Datasheet

www.tracopower.com Page 2 of 3
TMPS 10 Series, 10 Watt
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
Input Specifications
Input voltage – AC Input 85 – 264 VAC
– DC Input 120 – 370 VDC
Input frequency 47 – 63 Hz (designed to meet: 47 – 440 Hz)
Leakage current 0.25 mA max.
Inrush current – 115 VAC Input 20 A max.
– 230 VAC Input 40 A max.
No-load power consumption 0.15 W max.
External input fuse (required) 1.6 A (slow blow type)
Output Specifications
Voltage accuracy ±1 % typ. / ±2 % max.
Regulation – Input variation (Vin min. to Vin max.) 0.5 % max.
– Load variation (0 to 100 %) 1.0 % max.
Minimum load not required
Hold-up time – 115 VAC / 60 Hz Input 8 ms typ.
– 230 VAC / 50 Hz Input 40 ms typ.
Ripple and Noise (20 MHz bandwidth) 3.3 & 5 VDC models: 60 mVp-p max.
other models: 1 %(Vp-p) of Vout max.
Current limitation (long term condition may cause damage) at 150 % Iout typ. (foldback, auto recovery)
Short circuit protection hiccup, auto recovery
Output overvoltage protection 125 % of Vout typ. (by Zener diode)
Capacitive load 3.3 Vout model: 4‘400 µF max.
5.0 Vout model: 2‘200 µF max.
9.0 Vout model: 680 µF max.
12 Vout model: 390 µF max.
15 Vout model: 240 µF max.
24 Vout model: 100 µF max.
48 Vout model: 24 µF max.
General Specifications
Temperature ranges – Operating (natural convection: 20 LFM, 0.1 m/s) –25 °C to +70 °C max.
– Case temperature +95 °C max.
– Storage temperature –40 °C to +85 °C max.
Power derating 2.5 %/K above 50 °C
Temperature coefficient 0.02 %/K max.
Altitude during operation 2000 m max.
Switching frequency 30 - 65 kHz typ. (pulse width modulation)
Humidity (non condensing) 95 % rel. H max.
Isolation voltage (60 s) – Input/Ouput 4000 VAC
Isolation resistance – At 500 VDC 1GOhm min.
MTBF (MIL-HDBK-217F, at 25 °C ground benign) 450'000 h
Case material Plastic resin (UL94V-0 rated)
Pin material Tinned copper