Datasheet

Soldering Consideration

THL 10WI Series

Speciﬁcations can be changed without notice!

Make sure you are using the latest documentation, downloadable at www.tracopower.com

Application note: THL10WI-soldering-consideration,

page 1 of 1, rev.: 8. April 2016

Zone Reference Parameter

Preheat Rise temp. speed 3°C/sec max.

zone Preheat temp.: 100~130°C

Actual Peak temp.: 250~260°C

heating Peak time(T1+T2): 4~6 sec

Reference Solder: Sn-Ag-Cu, Sn-Cu, Sn-Ag

Hand Welding: Soldering iron: Power 60W

Welding Time: 2~4 sec

Temp.: 380~400°C

PAGE 1
THL 10WI Series Soldering Consideration Zone Preheat zone Actual heating Reference Parameter Rise temp. speed 3°C/sec max. Preheat temp.: 100~130°C Peak temp.: 250~260°C Peak time(T1+T2): 4~6 sec Reference Solder: Sn-Ag-Cu, Sn-Cu, Sn-Ag Hand Welding: Soldering iron: Power 60W Welding Time: 2~4 sec Temp.: 380~400°C Speciﬁcations can be changed without notice! Make sure you are using the latest documentation, downloadable at www.tracopower.
PAGE 2
THL 10WI Series Thermal Consideration Required output power derating in dependence of ambient temperature THL 10-241xWI 100 100 Natural Convection 20LFM 100LFM 200LFM 60 Natural Convection 20LFM 80 Output Power (%) 80 Output Power (%) THL 10-241xWI with heat-sink (THL-HS1) 400LFM 40 100LFM 200LFM 60 400LFM 40 20 20 0 0 ~ -40 0 20 40 60 80 ~ -40 100 110 0 THL 10-242xWI 100LFM 200LFM 60 400LFM 40 100 110 100LFM 200LFM 60 400LFM 40 20 0 0 ~ -40 0 20 40 60 80 ~ -40 1
PAGE 3
THL 10WI Series Ripple and Noise Output Ripple & Noise Nominal Max (0-20MHz bandwidth) 60 mVp-p 100 mVp-p (Over Line, Load & Temp.) --- 150 mVp-p Peak-to-peak output ripple & noise measurement test up +Vin +Out Single Output DC / DC Converter -Vin Copper Strip Cout -Out Scope Copper Strip Resistive Load +Vin +Out Copper Strip Dual Output DC / DC Converter Com.