Datasheet

Jenatschstrasse 1 · CH-8002 Zurich · Switzerland
Tel. [phone] · Fax [phone] · [e-mail] · www.tracopower.com
Rev. 05/12
DC/DC Converters
Heatsinks
Page 5 of 5
General Information
Note:
For volume orders converters will be supplied with heat-sinks preassembled and a TRACOPOWER side label attached to the converter.
Please contact factory for quotation. Separate heat-sinks are only available for prototypes and small quantity orders.
Assembly instructions for TEN and THN heatsinks
Example: TEN30-2412WI with heatsink TEN-HS2
The product label on converter has to be removed before mounting the heat-sink.
1. Lay out the assembly and check it for any missing components or for any
damage.
2. From the converter, remove the product label, including any remaining glue (best
with benzine) and, if required, apply a hand-written part number / lot number
marking on the side wall of the converter
3. Remove the protective foil from the adhesive thermal pad on the heat sink
4. Apply the heatsink to the converter and secure it by the two spring fixation clips
included with the heat sink assembly
Specifications can be changed any time without notice.