Datasheet
TBA 1 Series, 1 Watt
www.tracopower.com Page 2 of 4
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
Input Specifications
Input current at no load 3.3 Vin models: 30 mA typ.
5 Vin models: 25 mA typ.
12 Vin models: 15 mA typ.
24 Vin models: 10 mA typ.
Surge voltage (1 s max.) 3.3 Vin models: 5 V max.
5 Vin models: 9 V max.
12 Vin models: 18 V max.
24 Vin models: 30 V max.
Input filter internal capacitor
(external capacitor recommended)*
Recommended input fuse 3.3 Vin models: 0.8 A (slow blow type)
5 Vin models: 0.5 A (slow blow type)
12 Vin models: 0.2 A (slow blow type)
24 Vin models: 0.1 A (slow blow type)
Output Specifications
Voltage set accuracy 5 Vout models: ±3 % max. (at 60 % load)
other output models: ±3 % max. (at 80 % load)
Regulation – Input variation (at 1 % change of Vin) ±1.5 % max.
– Load variation See graphs below
Temperature coefficient ±0.02 %/K max.
Ripple and noise (20 MHz Bandwidth) 65 mVp-p typ. / 200 mVp-p max.
Short circuit protection continuous, automatic recovery
Start up time 30 ms max.
Capacitive load 3.3 Vout models: 3‘300 µF max.
5 Vout models: 2‘200 µF max.
9 Vout models: 1‘000 µF max.
12 & 15 Vout models: 470 µF max.
General Specifications
Temperature ranges – Operating (natural convection: 20 LFM, 0.1 m/s) –40°C to +95°C
– Case temperature +105°C max.
– Storage temperature –55°C to +125°C
Derating 5.0 %/K above 85°C
Humidity (non condensing) 95 % rel H max.
Isolation voltage – I/O isolation voltage (60 s) 1‘500 VDC
Isolation resistance (input/output) 1 GOhm min.
Isolation capacitance (input/output) 30 pF max.
Reliability, calculated MTBF (MIL-HDBK-217F at +25°C, ground benign) 2‘000‘000 h
Switching frequency 50 – 200 kHz (pulse width modulation)
Safety standards IEC/EN 62368-1, EN 60950-1
Environmental compliance – Reach www.tracopower.com/info/reach-declaration.pdf
– RoHS RoHS directive 2011/65/EU
*In case of long input lines or hot plug-in requirements, we recommended to use an external low ESR capacitor (22uF) close to the
converter’s input pins.