User Manual

461-460H06-0075-000 H006 14TH 75A ESC 说明书 142.5x210 80g书写纸
1/14
1. Hold the small button down and at the same time turn the ESC ON. Wait until the
ORANGE LED is on solid.
2. With the transmitter in neutral position, press the small button for just a moment.
3. The LED should now be solid GREEN. Pull full throttle and press the small button
for just a moment
4. The LED should now be solid RED. Press full brake and press the small button
again for a moment.
5. Wait a few seconds and the GREEN LED will come on solid along with a Blinking
BLUE LED. Turn off the ESC to SAVE your calibration settings.
6.You are now ready to run.
Before proceeding it is strongly recommended that you set both your brake EPA (End
Point Adjustment and throttle EPA to 100%. The new breed of ESC’s do not like more
electronic throw. You can adjust the throttle throw in other ways; through the
transmitter is most common using the curve. Similarly braking can best be adjusted
through the ESC. As a general rule start at 100% EPA and if you find you need to
reduce the EPA below 90% then you should consider making the ESC do more work
and lessen the braking strength at the ESC, resetting the EPA back to 100%.
Install and connect the ESC into your mini car, connecting the A, B and C motor leads
and the sensor wire. Insert the connector into channel 2 of your receiver (noting - + s).
Now you are ready to connect to your 2S battery.
Notice the small button on the ON-OFF switch. This button is used during the setup
process only.
Transmitter Calibration
Operation Mode For/Brake For/Brake/Rev For/Reverse
Reverse Speed 25% 50% 75% 100%
LVC Threshold None 2.9V/cell 3.0V/cell 3.2V/cell Custom:6.2V
Drag Brake 0% 4% 8% 10% 12% 15% 20% Custom: 35%
Initial Brake Drag Brake 0% 6% 12% 15% Custom: 25%
Drag Frequency 4KHZ 6KHZ 8KHZ 16KHZ
Full Brake 100% 95% 90% 85% 80% 75%
Brake Frequency 1KHZ 2KHZ 4KHZ 8KHZ 16KHZ 32KHZ
Power Profile Level1 Level2 Level3 .... Level7 Level8 Level9
Drive Frequency 2KHZ 4KHZ 8KHZ 16KHZ 32KHZ 64KHZ
Neutral DeadBand 0% 3% 6% 9% 12%
Temperature Set OFF 176f/80C 194f/90C
Boost Timing 0deg 1deg 2deg 3deg .... 60deg
Turbo Slope 3 deg/0.1s 6 deg/0.1s 12deg/0.1s 18deg/0.1s 24deg/0.1s
Fastest
Turbo Timing 0deg 1deg 2deg 3deg .... 30deg
Boost Timing RPM 500 1000 1500 2000 .... 14000 15000
Turbo Delay OFF 0.05sec 0.1sec 0.15sec 0.2sec .... 0.4sec
Boost Tinimg ACC 50RPM/deg 100RPM/deg .... 650RPM/deg 700RPM/deg
Hextronik Program Box V1.0 1/14th S Turbo
Specifications
Programming Box set flow Chart
正面 背面