User Manual

4
Connect ESC Throttle lead to Receiver in Channel 2.
Connect the motor to ESC.
Connect ESC to battery pack.
CONNECTION
1)
2)
3)
ESC CALIBRATION
How to calibrate the ESC?
Power
Switch
Receiver
Throttle
lead
Red power wire
(battery positive)
Black power wire
(battery negative)
Battery
Pack
ESC switch OFF
Connect the ESC to the battery and motor.
Turn on the transmitter.
Press and hold the ESC switch button for few seconds, the motor will ring long beep
once. After that, the red LED will blink the motor will ring like beep-beep-beep.....Then
you could release the ESC switch button now.
Keep the throttle trigger in neutral position, press the ESC switch
button once, the green LED will blink once then extinguish and the
motor will ring beep once which indicates the neutral position has
been set.
Calibration is necessary when the ESC powering on very first time, or whenever used with a
new/different transmitter. Individual transmitter’s signals for full throttle, full brake and neutral
are different. You must calibrate your ESC so that it will operate more effectively with your
transmitter.