Manual

INSTALLATION
Lamp-Ballasted Models (Ceiling Mount)
Select a location within 2 feet (0.6 m) of an electrical outlet.
Using the 6-foot (1.8 m) chain provided, suspend the lamp
assembly from a suitable ceiling mount.
Self-Ballasted Models (Ceiling or Wall Mount)
Select a location within 2 feet (0.6 m) of an electrical outlet.
Remove the reel from the bracket assembly by depressing
the release button on bracket A and sliding bracket B out of
the way.
Secure bracket A to a stud or joist using the #12 screws
supplied. Use all 3 screws to ensure security of the bracket.
Place the reel in bracket A. Insert bracket B into bracket A
until a click is heard. The reel is now securely locked in the
bracket.
OPERATION
Connect the primary cord to a power outlet that complies
with the electrical requirements listed on the lamp. See the
operating instructions enclosed with the lamp for full
information.
Pull the cord out to the desired length and stop. If the cord
does not hold, continue to pull the cord slowly, stopping
every 4 inches (10 cm). This will engage the lock. To
retract, pull the cord out 2 to 4 inches (5 to 10 cm) and guide
the cord slowly back into the reel.
• Do not pull hard on the cord when it is fully extended to
35 feet (10.7 m). This will cause malfunction of the
retracting spring.
Do not allow the cord to fly unrestricted back into the
reel.
MAINTENANCE
Remove dirt and grime as soon as it accumulates on the reel
case. Wipe clean with a dampened cloth. Do not use
solvents such as gasoline, turpentine, etc., to clean the
unit.
Keep the cord clean to ensure the smoothest automatic
retraction. Pull the cord to its full length and allow it to
retract through a clean, dampened cloth. Pull out the full
length again and allow it to retract through a clean, dry cloth
sprinkled with talcum powder.
GENERAL SAFETY INFORMATION
This unit should be used indoors. Do not use near potentially
dangerous locations such as flammable or explosive
atmospheres or near water.
Use only 3-wire extension cords that have 3-prong grounding
plugs and 3-pole receptacles that accept the unit’s plug.
Disconnect the unit from the power supply before servicing
or inspecting it for any reason.
CORD REEL
35 Foot (10.7 m), Retractable
Lamp-Ballasted Models
Self-Ballasted Models
A
Release
Button
B
6/07 AM07014
PRINTED IN U.S.A.

Summary of content (1 pages)