Instruction Manual

MN December22
www.tqbbrands.com.au Page 1 of 3
Evaporative Cooler
Float Valve Replacement
Instructions
Product Codes: 1027T, 1035T
Float Valve Replacement Instructions
1. Disconnect your shop water supply hose from the float valve inlet.
2. Disconnect the evaporative cooler from the power source.
3. Remove cooling pad fastening sheet [item 27] then remove dust proof sheet [item 26] and cooling pad [item
25] by removing the Phillips head screws.
The Symptoms related to an incorrectly installed Float Valve are as follows;
Water reservoir will not fill using float valve system
Water reservoir overfills using float valve system
Water reservoir underfills using float valve system
DISCONNECT THE EVAPORATIVE COOLER FROM THE POWER
SOURCE PRIOR TO ANY MAINTENANCE PERFORMED

Summary of content (3 pages)