Installation Guide

Date : October 18th 2019
DM3G Low-band
Ref : Installation Guide
Edition 1.2.0
Page
7/27
The DM3G installation is critical to its well-functioning. We recommend you to follow installation
instructions carefully.
The DM3G must never be installed :
- in a confined place which would not enable airflow
- near a heat source
RF Exposure limit :
The antenna gain used with this device should be 0 dBi or less and all persons should maintain
a minimum separation distance of 141.05 cm for general uncontrolled exposure and general
controlled exposure.
Staff competences :
It is recommended that DM3G shall be installed by electrical accredited people.
Note : A bad setup could lead to an unusual heating of the device which could affect its
function. TPL Systèmes denies any responsibility in case its products would not be correctly
installed.