Installation Guide

Date : October 18th 2019
DM3G Low-band
Ref : Installation Guide
Edition 1.2.0
Page
6/27
2 Safety instructions and Regulations
Before operating the product read this manual
! Any changes or modifications of this product not expressly approved by the party
responsible for compliance could void your authority to operate this equipment.
! Users of DM3G Low-Band should ensure that the regulation of frequency allocations and
applications are respected and must also check with local authority of frequency
regulation in their respective country.
! Use the equipment with supplied accessories only.
! Do not use this product if it is visibly damaged.
! This product may malfunction if not installed and used in accordance with this manual.
The use of radio systems near to other electrical equipment, metallic surfaces or
influenced by architectural obstacles may affect the proper function respectively the radio
coverage.
FCC STATEMENTS :
FCC Part 15.19 warning statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions : (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
FCC Part 15.21 warning statement
Note : The grantee is not responsible for any changes or modifications not expressly approved
by the party responsible for compliance. Such modifications coud void the user’s authority to
operate the equipment.
FCC Part 15.105(b) warning statement (Only required for 15.109-JBP devices)
NOTE :This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures :
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help