Installation Guide

Date : October 18th 2019
DM3G Low-band
Ref : Installation Guide
Edition 1.2.0
Page
24/27
When MCE battery is discharged, a beep tone is transmitted every 15 seconds for 1 minute.
The « Battery low » message is displayed. When critical discharge level is exceeded, MCE
automatically switches off after 30 seconds.
When MCE is placed on its support, battery is charging. When it starts charging, MCE plays
an audio beep tone and battery icon animates. The red LED located at the MCE top lights up
(see paragraph 8.1). This enables to control charge status when MCE is off.
When charging phase is over, battery icon sets to the “Battery full” position and the red LED
switches off.
Bluetooth radio range from MCE to terminal depends on battery charge level.
It is therefore recommended to keep the MCE battery well charged.
Charging the battery may be longer when MCE is turned on during the charge cycle.
If battery is too low to enable the MCE to switch on, message ‘battery low” will be displayed
and MCE will switch off to avoid damages to battery.
9 How to start
Screenshots included in this handbook are subject to change with terminal software version.
The radio device switch-on is made by pushing the key on the MCE.
DM3G terminal is switched off by a long-press (3s) on key on the MCE.
9.1 Main screen
When you power on the DM3G main screen (in analog mode) is displayed :
GPS status
Position fixed
Position under calculation
Time
Time is given in digital radio mode only, by digital radio repeater.
--:--
Chan.Menu
023
3 Common1
–122