Installation Guide

Date : October 18th 2019
DM3G Low-band
Ref : Installation Guide
Edition 1.2.0
Page
23/27
8.2 Bluetooth MCE pairing
DM3G BT mobile is provided with an unpaired MCE BT.
User must pair the MCE BT with the DM3G BT on first start up.
The procedure is described hereafter.
- Mobile is identified by its serial number printed on a tag at the terminal rear. Note this
number before beginning
- Power on the terminal
- Power on the MCE BT by a press on MCE green key
- TPL Systèmes logo and search indicator are displayed as below
During scanning, long-press key
- Directly dial “8471” on keyboard
- Messages below are displayed
or validate by oui / yes, then
- Select Modifier / Modify
- Select Nouveau / New
o MCE BT searches for Bluetooth equipments and displays serial numbers (or
MAC addresses) of found equipments
- When DM3G serial number appears
o Press “Arrêter / Stop”
o Select DM3G serial number in the displayed list with the arrows
o Press on “Valider / Validate”
- MCE boots up and connects to DM3G after a few seconds scanning.
- Main screen is displayed
8.3 Battery charge
Status of battery charge can be seen from the display battery icon :
Battery full
Battery low
(blinking)
Battery discharged
Bluetooth network scanning
bar
reset EEPROM ?